Laying porcelain tiles

Laying is an easy task, but it is important to follow some basic rules when working. Especially when laying the tiles on the wall, more experience is needed on the part of the master. You should always be careful what you are doing and plan your next steps for further laying the tiles. The first step is to apply the primer, in most cases this is lime plaster with cement mortar, which should be up to 2 centimeters thick. There are cases in which it needs to be thicker and then two layers are applied. It is good to score the primer with a trowel, this is for better adhesion.

The next step is to plumb and determine the places where the guide tiles will be laid. For an easier and clearer indication of the floor level, wooden slats can be used along the length of the wall. The upper edge represents the future floor level. The guide tiles are 4 and are placed about 10-15 cm from the corners, after which nail wedges are driven in, on which one guide level string is easily placed. The possibility with which you can make the required size tiles is by cutting manually or by machine, the hardness and size of the tiles or the difficulty of the cut also plays an important role.

Even if it is the highest quality faience , it can break, so do not buy a tile with precision. When it comes time to tile, it is necessary to start from the bottom up and is performed from left to right. These tiles can be placed in three ways /mainly/. One of them is a joint with / at the joint, the other is with staggered joints or diagonally. After the solution is made, while strictly following the manufacturer's instructions, take some of it with a trowel and smoothly apply it to the back of the tile. Place the tile in the designated place and then be sure to press it with your hand to the wall. The tile is then finally adjusted, which is done by tapping with a rubber hammer.

It is also possible with the palm of your hand, but if you have a large area to tap, you risk hurting your palm. Whether you are laying tiles, faience or quality clinker , they must all be laid correctly with a light tap so that they last a long time and do not shift or break afterwards. After laying the tiles, it is time for the plastic crosses. They come in different sizes, it all depends on whether you want to have wider joints or narrower ones. These crosses are intended to ensure that the joints between the tiles are the same size after they are laid. After the tile has completely dried, they are removed and reused. When a gap is obtained between the wall and the slab, they must be filled with mortar using a funnel or other convenient container.

The grouting of the cladding is done with ready-made grout mixtures. They are available in all specialized stores for building materials, and if you cannot find them, you can make them yourself from white cement and water. It is important to note that all grout mixtures are applied with a special rubber spatula, and after applying them, you must clean the areas with a sponge or cloth and water. There are different technologies for installing faience tiles. It is important that the base is perfectly aligned and smoothed before any actions. When purchasing adhesives that contain a volatile diluent, it is desirable that the tiles are dry.

Every home needs maintenance. If you are going to do a renovation and you can do it yourself, it is very important to constantly monitor what is being done in your home. Make a plan and schedule to meet the promised deadlines. When starting a renovation, preparing the room is of great importance. Make sure to save the furniture you hold dear. Remember that the end result is important, not the view you see during the renovation itself.